BUCKINGHAM MFG.
PN 355TQ2
–
Ladder Lash Straps
Instructions / Warnings
The Buckingham 355TQ2 Ladder Lash straps are used to lock and stabilize the ladder to the pole. The system consists of two
straps (Fig. 1a
) that are constructed using 1” webbing with a slip through cam buckle, snap and connection D
-ring. The
straps connect to the top rung of the ladder top section using a girth hitch loop, wrapped around the pole and connected
between the 4
th
and 5
th
rung of the bottom section of the ladder using the snaps and D-rings. The straps are stored in the
storage bag attached to the ladder top section when not in use (Fig. 1b
–
1c).
Note: hardware / material colors may vary from that shown below.
Installation of the 355TQ2 on the Ladder:
1.
Place the girth hitch loop of the ladder lash strap under the top rung (left side) of the top section of the ladder (Fig. 2)
2.
Pass the snap end, cam buckle, and adjustment end loop through the girth hitch loop (Fig. 3)
3.
Pull the remainder of the strap through the girth hitch loop until the loop is tight to the rung (Fig. 4)
4.
Repeat steps 1
–
3 for second strap placed on the top rung (right side). Both straps need to be attached to the top rung of
the top section of the ladder (Fig. 5)
Installation of the Ladder Mounted Storage Bag on the Ladder:
1.
Lay the ladder on the ground with the front side of the ladder facing up (Fig. 6). Place the ladder mounted storage bag
under the life line and between the top two rungs of the ladder
’s
top section (Fig. 6) with the flap facing up (Fig. 7). Note:
when ladder is set on the pole ready for use, the BUCK logo of the storage bag and the flap (with the hook and loop closure)
will face away from the pole.
2.
Attach the two upper cover straps (Fig. 1b) around the top rung of the top section of the ladder and tighten so the bag is
close to the top rung (Fig. 8).
3.
Next adjust the length of the two lower straps (Fig. 1b) and loop them around the next lower rung of the ladder top section,
snap the quick connect buckles together and pull on the loose ends of the straps to tighten (Fig.8 - 9).
355TQ2.Doc Rev. 11/08/17
1 of 5
P/N 232288
Fig. 2
Fig. 3
Fig. 4
Fig. 1a
Girth Hitch Loop
(with protective cover)
Cam Buckle
Snap and Connection D-ring
Adjustment End Loop
Fig. 5
(One Strap Shown)
Ladder Mounted Storage Bag
Fig. 1b
Fig. 1c
Upper Cover
Straps
Lower
Straps