30
Need help or have any questions? Call us at 1-714-963-0329
❑
When satisfied with the fit, use pieces of masking tape
to hold the canopy in place.
❑
Set the canopy onto the fuselage and center it over the cockpit opening. Look from the front to make sure the canopy
is centered with the middle of the fuselage, too.
❑
Carefully drill four 1/16" pilot holes through the canopy
and into the fuselage for the mounting screws. Locate two
holes on each side of the canopy, one near the front and one
near the back.
❑
Install the canopy using four 2mm x 6mm wood screws. Be careful not to overtighten the screws or they may strip.
Step 2: Mounting the Canopy
❑
# 1 Phillips Head Screwdriver
❑
Adjustable Wrench
❑
Excel Modeling Knife
❑
Scissors
❑
Electric Drill
SECTION 13: FINAL ASSEMBLY
YOU'LL NEED THE FOLLOWING SUPPLIES:
❑
5/64" Drill Bit
❑
Ernst Airplane Stand
❑
Ruler
❑
Scotch
®
Tape
YOU'LL NEED THE FOLLOWING PARTS:
❑
{1} Decal Set
❑
{1} Molded Spinner
❑
{2} 2mm x 10mm Wood Screws
Step 1: Applying the Decals
❑
Using a clean cloth, wipe the airframe down completely to remove dust, debris and oil.
