11
Need help or have any questions? Email us at [email protected]
❑
Set the stabilizer onto the fuselage.
❑
Line up the centerline mark you drew on the trailing edge
of the stabilizer with the center of the fuselage.
❑
Hold the stabilizer temporarily in place (only at the
trailing edge) using a pin.
IMPORTANT
The stabilizer should be pushed forward completely. A precovered balsa block is provided to fill the gap behind the
stabilizer and will be installed later.
❑
With the trailing edge centered, pivot the front of the
stabilizer until the triangle stock lines up with the fuselage
sides.
❑
When satisfied with the alignment, hold the front of the
stabilizer in place with a pin.
❑
Making sure the stabilizer is held firmly in place, look
from the front of the airplane at both the wing and the
stabilizer. When aligned properly, the stabilizer should be
parallel to the wing.
IMPORTANT
If the stabilizer is out of alignment, remove it and use 220 grit sandpaper with a sanding block to sand down the higher side
of the stabilizer mounting platform, then reinstall the stabilizer and check the alignment again. Repeat this procedure until
you are satisfied with the alignment.
☛
If the stabilizer is not parallel to the wing, the airplane will not fly straight.
C=C-1
