28
Need help or have any questions? Call us at 1-714-963-0329
❑
# 0 Phillips Head Screwdriver
❑
Excel Modeling Knife
❑
Scissors
❑
Electric Drill
❑
1/16" Drill Bit
SECTION 11: INSTALLING THE COWL
YOU'LL NEED THE FOLLOWING SUPPLIES:
❑
Ernst Airplane Stand
❑
Pencil
❑
220 Grit Sandpaper w/Sanding Block
❑
Masking Tape
YOU'LL NEED THE FOLLOWING PARTS:
❑
{1} Molded Plastic Cowl
❑
{4} 2mm x 6mm Wood Screws
Step 1: Aligning the Cowl
❑
When satisfied with the fit, use pieces of masking tape
to hold the cowl firmly in place.
❑
Using a pencil, mark the locations of the five mounting
screw holes onto the cowl.
IMPORTANT
If you hold the fuselage up against a bright light, you can
easily see the cowl mounting blocks within the cowl. This
will make it easy to position the holes.
❑
Set the cowl onto the fuselage and align it.
☛
☛
☛
☛
☛
You may have to trim the edges of the cowl slightly to get a perfect fit.
❑
Using a pair of scissors, cut out the cowl along its molded
scribe line.
❑
Sand the edges of the cowl smooth and straight using
220 grit sandpaper with a sanding block.
