27
Need help or have any questions? Email us at [email protected]
❑
Connect your radio system and plug the aileron servo into the receiver. Double-check that the aileron trim lever on
your transmitter is centered and turn on the radio system.
❑
Install the servo horn onto the servo, making sure it's
centered.
☛
The servo horn should point toward the wing tip.
❑
Install the retaining screw to secure the servo horn into
place.
❑
Using a modeling knife, cut off a 1/4" long piece of clevis retainer tubing. Slip the piece of tubing onto the base of
one clevis.
❑
Use a couple of pieces of masking tape to hold the aileron centered.
❑
Thread the nylon clevis onto the threaded end of the
pushrod wire until the clevis lines up with the holes in the
control horn.
❑
Carefully snap the clevis into the third hole out from the
base of the control horn and slide the piece of silicon tubing
up over the clevis to secure it into place.
❑
Remove the masking tape from the aileron.
Step 3: Adjusting the Pushrods & Control Throws
❑
With your radio system plugged in and turned on, check to make sure both ailerons and aileron servos are centered.
If necessary, use the trim lever on the transmitter and/or thread the clevises in or out to center them. Double-check that the
ailerons are moving in the proper direction.
❑
Check the control surface throws by measuring from the
widest point of each control surface. Both ailerons should
move both up and down 3/8".
❑
If necessary, make adjustments to the control throws
using the same technique as with the elevator rudder.
❑
Repeat the previous procedures to install the second aileron pushrod assembly.
