29
Need help or have any questions? Email us at [email protected]
❑
Drill 1/16" pilot holes into the cowl and through the cowl
mounting blocks for the wood screws.
☛
Do not install the cowl yet.
❑
Remove the masking tape and cowl from the fuselage.
❑
Using a modeling knife, carefully cut open the two
molded air-exit holes in the back of the cowl and cut an
air-intake hole in the front of the cowl.
WARNING
It's imperative to have sufficient airflow through the cowling
and belly pan to cool the motor, ESC and flight battery.
❑
Install the cowl using five 2mm x 6mm wood screws. Be careful not to overtighten the screws or they might split or
distort the plastic.
❑
# 0 Phillips Head Screwdriver
❑
Scissors
❑
Electric Drill
❑
1/16" Drill Bit
SECTION 12: INSTALLING THE CANOPY
YOU'LL NEED THE FOLLOWING SUPPLIES:
❑
Ernst Airplane Stand
❑
Pencil
❑
220 Grit Sandpaper w/Sanding Block
❑
Masking Tape
YOU'LL NEED THE FOLLOWING PARTS:
❑
{1} Molded Clear Canopy
❑
{4} 2mm x 6mm Wood Screws
Step 1: Aligning the Canopy
Step 2: Mounting the Cowl
❑
Using a pair of scissors, cut out the canopy along its molded scribe line.
❑
Sand the edges of the canopy smooth and straight using 220 grit sandpaper with a sanding block.
