19
Need help or have any questions? Email us at [email protected]
❑
# 1 Phillips Head Screwdriver
❑
Excel Modeling Knife
❑
Electric Drill
❑
1/16" Drill Bit
SECTION 7: INSTALLING THE SERVOS
YOU'LL NEED THE FOLLOWING SUPPLIES:
❑
Ernst Airplane Stand
❑
Ruler
❑
Masking Tape
Step 1: Installing the Rudder & Elevator Servos
❑
Use a piece of masking tape to hold the elevator and
rudder servos together side-by-side as shown.
❑
Install the rubber grommets and brass collets onto your
elevator and rudder servos. Make sure to install the collets
with the flanges toward the bottom of the servos.
❑
Carefully remove the servo hatch cover from the bottom of the fuselage (behind the wing saddle). The hatch cover is
temporarily held in place from the factory with double-sided tape.
❑
Set the servos onto the servo rails taking note of their
location and the position of the servo output shafts.
☛
So that the servo arms will be lined up with the pushrods
when they are installed later, the servos should be centered
between the fuselage sides .
IMPORTANT
Run the servo leads out toward the front of the airplane,
underneath the wing hold-down block.
