WaterLogic WL7, Техническое руководство

Страница: 17 / 47

17
ENG2036-16/01/19
0
3.2 SANITISING INSTRUCTIONS
INSTALLATION INFORMATION
The disinfection of the product after installation is very important to ensure that there is no
residue on the machine due to transport and testing that can leave a bad taste in the water.
Always ensure proper ventilation and use proper personal protective equipment such as gloves
and eye protection when using chemicals. Refer to material safety data sheet for specific
requirements of each chemical product. Take all necessary precautions to prevent sanitiser from
contacting eyes, clothing, and any other surfaces it could damage.
!
Turn OFF the water supply and open the
front panel [9] to access the filter.
Ensure CO
2
supply is on and dispense 500 ml
of sparkling water from the faucet. This will
let the pump refill the tank with water that
contains sanitiser solution.
Turn ON the water supply.
Dispense cold water until water with
sanitiser solution comes out the faucet.
Replace the filter with the housing with
the sanitiser inside (30 ml). Bypass the other
filters if applicable.
Turn OFF the water supply and replace the
filter housing with the original filter.
Ensure the green (chapter 2.5 [22]).
Compressor and heater switch is OFF.
Repeat the process with the ambient water.
1
7
3
5
2
8
4
6
9