![background image](http://html2.mh-extra.com/html/waterlogic/wl400-series/wl400-series_manual_3662927066.webp)
WL400
Manual Page 66
–
Revision: 10-23-2019
2.
Red Power Switch, Green Heater and Compressor Switch are lit but the red LED
on the Front is not lit
Possible Reason
Solution
Bad Transformer
Replace Transformer
Black Power Connector to the
PCB is not properly connected
Properly connect.
Bad Front PCB
Replace Front PCB
Defective Red Power Switch
Replace Red Power Switch
Defective Green Heater and
Compressor Switch
Replace Green Heater and Compressor Switch
3.
Compressor Runs But Does Not Chill
Possible Reason
Solution
Condenser is dirty
Clean the condensing coil of any obstructions or dust.
Reduction of airflow into unit.
Make sure unit is not under minimum ventilation requirements (2
to 4 inches).
Compressor is running very
hot.
Low or lost refrigerant. Refrigerant recharge required.
Содержание WL400 Series
