WaterLogic WL400 Series, Руководство пользователя

Страница: 63 / 84

WL400 Manual Page 63 – Revision: 10-23-2019
FAULT CODE TROUBLESHOOTING INDEX
1. Icon and Alarm on continuously – Leak Detector Sensor Alarm
2. Icon ON Continuously, Alarm for 20 Seconds – the Firewall UV system is not
detecting adequate dose of UV to ensure safe water
1. FAULT CODE: Icon and Alarm on continuously – Leak Detector Sensor Alarm
There are two leak detector sensors in the WL400 Water Treatment Systems.
Possible Reason Solution
Leak Tray Full
Check for water in base cabinet by opening and removing
front cover.
If water is found in leak tray, dry out leak tray.
Unplug unit to reset fault and determine where the leak is.
Leak Tray Full – with no alarms
Verify the drip tray leak clips are installed.
If the drip tray leak clips are installed, the water TDS may be too low. You may need to bend
the drip tray sensor tabs inward (closer together) to improve the performance of the signal
returning to the board.
`Water in Base Cabinet
If no water is found in the base cabinet, open Top Cover of
WL400 Water Treatment System and remove Right Side
Panel to determine where leak is.
If water is found, dry out leak tray, unplug unit to reset fault
and determine where the leak is.