Waterite Fusion 360, Инструкция по установке и эксплуатации

Страница: 7 / 16

7
Step 5. Install the Drain Saddle Assembly
1. Select the location to install the drain saddle assembly. This is usually on the sink
drainpipe and needs to always be located above the “S” trap.
2. Position the drain saddle assembly in the selected location and mark the spot through the
outlet with a pencil or marker.
3. Drill a ¼” hole at the marked
spot. Strip the backing paper
from the adhesive side of the
foam gasket and position on
the inside of the drain clamp
back plate, aligning the gasket
hole with the outlet. Attach the
drain clamp back plates to the
drainpipe, aligning the push-on
fitting with the drilled hole.
Using the screws provided,
tighten the clamp snugly. DO
NOT OVERTIGHTEN. See
Figure 4.
4. You will find the push-on drain line fitting at the lower rear of the RO cabinet. The other end
of the drain tube may be inserted directly into the push-on drain clamp fitting, using
instructions in Step 8 below. Do not attach the drain tube at this time.
Step 6. Connect the System Tubing
Note:
All fitting joints on your RO are locked into place with a blue ‘C-
clip’ that holds the fitting collet in the locked position. These C-clips must
be removed before the tube will release and must be replaced once the
tube is re-inserted to assure a secure joint. Simply slide the C-clip in and
out of place with a pair of needle-nose pliers.
Figure 4.