INFINIUM ∞ ECO-V150
Variable Speed Pump
I pg 13
Programing
Introduction
The INFINIUM ECO V-150 uses a premium efficiency variable speed motor that provides
tremendous program flexibility in terms of motor speed and time settings. The variable speed
motor is intended to enable running at the lowest speeds needed to maintain a sanitary
environment, which in turn minimizes energy consumption. Pool size, the presence of additional
water features, chemicals used to maintain sanitary conditions, and environmental factors will
impact optimal programming necessary to maximize energy conservation.
The integrated electronics interface controls the speed settings as well as the run durations.
The INFINIUM ECO V-150 can run at speeds ranging between 600 and 3450 RPM and is rated
for 208-230 Vrms at an input frequency of 60 Hz.
Navigation Overview
>
+, - Increases/decreases selected value
>
Pressing any key following a change accepts the current value displayed inside the setting
Note:
The START button must be pressed for the INFINIUM ECO V-150 to operate. The START
LED will illuminate after the button has been pressed indicating the INFINIUM ECO V-150 is
capable of operating. Pressing the stop button will turn off the START LED and stop the motor
if running
Maintenance
•
Clean strainer basket regularly. Do NOT strike basket to clean. Inspect strainer cover
gasket regularly and replace as necessary.
•
Waterco pumps have self-lubricating motor bearings and shaft seals. No lubrication
is necessary.
• Keep motor clean. Insure air vents are free from obstruction to avoid damage. Do
NOT use water to hose off motor.
• Occasionally, shaft seals must be replaced, due to wear or damage. Replace with
genuine Waterco seal assembly kit.
Storage/Winterization
!
!
WARNING – Separation Hazard. Do not purge the system with compressed air.
Purging the system with compressed air can cause components to explode, with risk
of severe injury or death to anyone nearby. Use only a low pressure (below 5 PSI),
high volume blower when air purging the pump, filter, or piping.
!
!
ATTENTION – Allowing the pump to freeze will void the warranty.
!
!
ATTENTION – Use ONLY propylene glycol as antifreeze in your pool/spa system.
Propylene glycol is non- toxic and will not damage plastic system components; other
anti-freezes are highly toxic and may damage plastic components in the system.
!
!
WARNING – To avoid dangerous or fatal electrical shock hazard, turn OFF power
to motor before draining pump. Failure to disconnect power may result in serious
personal injury or death.
Storing Pump For Winterization
•
Drain water level below all inlets to the pool.
•
Drain all water from pump and piping when expecting freezing temperatures or when
storing pump for a long time (see instructions below).
• Remove drain plugs from bottom of strainer body, and remove strainer cover from
strainer housing.
• Disconnect pump from mounting pad, wiring system (after power has been turned
OFF), and piping system.
• Keep motor dry and covered during storage. To avoid condensation/corrosion
problems, do NOT cover or wrap pump with plastic film or bags.
Figure 1 : V-Green 165 User Interface Button Descriptions