Warnock Hersey northfire dvr36h, Инструкция по установке и эксплуатации

Страница: 14 / 26

13
INSTALLATION INSTRUCTIONS
Cont...
ELECTRICAL CONNECTIONS (for optional convection fan kit FK 36/38 only)
•
Install the fan first. Remove the lower louvers and gently place the bottom front lip of the blower
mounting bracket into the opening. Slide the blower assembly into the bottom of the fireplace.
Rotate the blower into position. Be careful not to damage the fan blades. The fan blades will now
face towards you. Line up the holes on fan bracket to the mounting bracket at the bottom of the
fireplace. Place a screw at each of the three holes and tighten.
•
Run 120VAC power line through the left side of the fireplace and into the bottom of the gas
fireplace.
•
Be sure to connect a grounding wire to the side of gas fireplace. Use any screw hole on the side for
this purpose.
•
Slide the thermal snap switch into the fork like bracket underneath the left side of the firebox.
•
Neatly tie down and tuck the wires down at the bottom and to the back of the fireplace.
•
CAUTION: Do not allow any wires to touch the bottom of the firebox. Otherwise, the wires will
melt and short-out.
•
Screw the speed controller bracket to the bottom left sidewall of the gas fireplace.
WIRING DIAGRAM
SPEED CONTROL
LINE
CONVECTION BLOWER
GROUND
110F (43ºC) N.O.
THERMAL SNAP
NEUTRAL
SIDE OF GAS
FIREPLACE
120 VAC
VALVE CONNECTIONS
PILOT
ASSEMBLY
REMOTE WALL SWITCH
OPTIONAL
THERMOSTAT
THERMOPILE
SPARK ELECTRODE
THERMOCOUPLE
PILOT
SPARKER
f i r e - p a r t s . c o m