DISASSEMBLY OF BATCH BOWL PARTS –
Model VCM1000SK & VCM1000PK, VCM1000SE, VCM1000PE
ALWAYS UNPLUG THE CORD BEFORE DISASSEMBLING.
• Turn the bowl cover clockwise until the safety interlock tab on the cover is
disengaged from the magnetic safety interlock switch in the tower, and the
tabs are clear of the groove in the tower. The bowl handle will be at a position
between 7 o’clock and 9 o’clock. In this position, the cover can be lifted off
the bowl.
• Remove the large food pusher from the feed tube. Remove the small pusher
from the large pusher.
Disassembly when Removing the S-Blade
• Remove the work bowl from the unit by rotating clockwise to disengage the
tabs on the bottom of the bowl platform from the work bowl. When the bowl
handle is on the left (about 7 o’clock), you can gently lift the bowl straight up
and out.
It is recommended that you remove the bowl from the motor base before
you remove the S-Blade.
• To remove the blade, keep a slight downward pressure on the top of the
center hub of the blade while removing the bowl from the motor base.
This will form a seal to prevent food particles from spilling into the center
tube of the bowl, and onto the motor base or the work surface. Then remove
the S-Blade from the bowl. Handle the S-Blade with caution; the blades are
extremely sharp.
ASSEMBLY OF CONTINUOUS FEED CHUTE PARTS
Model VPA1000K - Accessory Pack
• Clean and sanitize the motor base, and wash, rinse, and
sanitize the continuous feed chute, cover, slinger disc,
food pusher, food pusher insert and processing tools
prior to initial use.
• Place the base on a counter or table near an electrical
outlet. Position it so that you are looking at the front of
the unit and can see the control paddles. Be certain that
the cord is unplugged and the OFF ( ) switch paddle
has been pressed. Do not plug in the cord until the
processor is completely assembled.
• Pick up the continuous feed chute, holding it in both
hands with the chute pointing in the 4 o’clock position.
Place the chute on the base, fitting its center opening
over the motor shaft. Align the bowl locking slots on the
bottom of the chute to the left of the black locking tabs
on the side of the bowl platform (motor base).
• Press the chute down so the round lower rim of the
chute fits around the
circular platform.
5
®
ON
PULSE/OFF
