W&H LINA MB17, Инструкция по эксплуатации

Страница: 48 / 76

48
Alarms
Alarms Alarms
Alarms
NOTE: for any alarm not listed in this table, call technical service.
Alarm Alarm Alarm Alarm code code code code DESCRIPTION DESCRIPTION DESCRIPTION DESCRIPTION ACTION ACTION ACTION ACTION
E010 E010 E010 E010 Power failure during a cycle Load cannot be considered sterile. Repeat the cycle.
E02x E02x E02x E02x Internal voltage error Switch the sterilizer OFF and ON. If the problem persists call service.
E041
E041 E041
E041 Cycle counter lost
Switch the sterilizer OFF and ON. If the problem persists call service.
NOTE: Initiating a sterilization cycle is still possible.
E042 E042 E042 E042 Internal clock error
Set date and time - Switch the sterilizer OFF and ON. If the problem persists call service.
NOTE: Initiating a sterilization cycle is still possible.
E060 E060 E060 E060 Internal voltage error
Disconnect optional accessories from 24VDC rear plug - switch the sterilizer OFF and ON. If the problem
persists call service.
E080 E080 E080 E080 Internal overheating Check the dust filter and ensure that the sterilizer fan is not blocked.
E090 E090 E090 E090 Internal voltage error Switch the sterilizer OFF and ON. If the problem persists call service.
E100
E100 E100
E100 Phase timeout Check water level in the clean water tank. Reset the thermal overload. If the problem persists call service.
E101
E101 E101
E101 Internal probe error Switch the sterilizer OFF and ON. If the problem persists call service.
E102 E102 E102 E102 Phase timeout Check water level in the clean water tank. Reset the thermal overload. If the problem persists call service.
E107 E107 E107 E107 Overpressure during the pre-vacuum phase If the problem persists call service.
E121 E121 E121 E121 Internal probe error Switch the sterilizer OFF and ON. If the problem persists call service.
E130
E130 E130
E130 Overpressure during the sterilization phase
Clean the chamber and the chamber furniture from residuals of detergents, disinfectants and other
chemicals.
Replace the clean water if it is suspected to be contaminated with chemicals.
Ensure all the load is clean rinsed and free from any chemicals before sterilizing.
Repeat the cycle. If the problem persists call service.
E131
E131 E131
E131 Temperature fluctuation during the steril. phase
E140
E140 E140
E140 Low pressure during the sterilization phase
E150 E150 E150 E150 Low temperature during the sterilization phase
E160 E160 E160 E160 Over temperature during the sterilization phase
E163 E163 E163 E163 Overpressure detected
E180
E180 E180
E180----E181
E181 E181
E181 Internal probe error. Switch the sterilizer OFF and ON. If the problem persists call service.