W&H LINA MB17, Инструкция по эксплуатации

Страница: 31 / 76

31
Customization of cycle parameters
Customization of cycle parameters Customization of cycle parameters
Customization of cycle parameters
MENU MENU MENU MENU SUB SUB SUB SUB----MENU MENU MENU MENU WHAT IT DOES AND HOW TO SET IT WHAT IT DOES AND HOW TO SET IT WHAT IT DOES AND HOW TO SET IT WHAT IT DOES AND HOW TO SET IT
(*)
(*) (*)
(*)
Sets the cycle as the default cycle, Sets the cycle as the default cycle, Sets the cycle as the default cycle, Sets the cycle as the default cycle, means it will appear first on the start screen. After pressing OK, press OK on YES to set the cycle as
the default cycle (the other cycles will be automatically set to NO); press BACK to exit without saving.
(*)
(*) (*)
(*)
Unhides Unhides Unhides Unhides/hides a cycle. /hides a cycle. /hides a cycle. /hides a cycle. Once a cycle is hidden, it will no longer be visible in the menus and thus it will be impossible to launch it.
After pressing OK you can scroll between YES and NO with the UP and DOWN buttons. Press OK on YES to hide the cycle, press OK on NO to
unhide it, press BACK to exit without change.
(*) (*) (*) (*) Sets Sets Sets Sets the plateau temperature. the plateau temperature. the plateau temperature. the plateau temperature.
After pressing OK, an asterisk will appear near the current value, indicating that it can be changed
by pressing UP or DOWN. After programming the desired value, press OK to confirm or BACK to exit
without saving.
(*) (*) (*) (*) Sets Sets Sets Sets the the the the duration duration duration duration of of of of the plateau the plateau the plateau the plateau phase phase phase phase....
(*)
(*) (*)
(*) Sets
Sets Sets
Sets the
the the
the duration
duration duration
duration of
of of
of the
the the
the drying
drying drying
drying phase
phase phase
phase....
(*) The parameters that you can actually change depend on the country of use, the model of the sterilizer and the access level.
After selecting a cycle, press UP or DOWN until the SETUP option appears and confirm (OK).
Scroll the sub-menu options by pressing UP or DOWN (the current value is displayed) and
follow the instructions in the table below.
You can customize a cycle program by setting certain parameters according to your own sterilization protocol.
The parameters you can set are the drying time, the plateau time, and the plateau temperature (see note(*) below).
Changing the plateau time and temperature Changing the plateau time and temperature Changing the plateau time and temperature Changing the plateau time and temperature
It is strongly recommended not to decrease neither the plateau time nor the plateau temperature, as these are sterilization
parameters that shall comply with stringent requirements of legal, regulatory and scientific nature.
Changing the drying time
Changing the drying time Changing the drying time
Changing the drying time
The duration of the drying time can be increased or decreased according to the characteristics of the load. When changing the
drying time, ensure that the load is always dry at the end of a sterilization cycle in order to avoid wicking of moisture and,
potentially, microorganisms from hands, gloves or environmental surfaces.