Wallenstein BXT36S, Руководство оператора

Страница: 34 / 72

6.9.2 Chip Wood
WARNING!
Do not reach into the chipper hopper. There
are sharp rotating parts that can trap, cut, and/
or sever your fingers, hands, toes, or feet. Use
a stick or branch to push material that does not
move into the machine.
If the machine is blocked, set the machine to a
safe condition, and then clear the blockage.
W004
IMPORTANT! Do not put metal objects, bottles, cans, rocks,
glass, or other unapproved material into the machine. These
items will damage the machine.
If these items get into the machine, set the machine to
a safe condition before you remove them. Examine the
machine for damage and loose parts.
The operator is responsible to be familiar with and obey all
operating and safety procedures.
1. Set up the machine.
For instructions, see
Set Up the Machine on page 31 .
2. Prepare the material.
For instructions, see
Prepare the Material on page 33.
3. Start the machine.
For instructions, see
Start the Machine on page 30 .
4. Make sure that the engine speed is set to FAST and the
rotor is at full speed (wait three minutes).
5. Slowly, put material (branches and brush) into the chipper
hopper until it engages with the rotor.
The rotor will draw the material into the machine. Do not
attempt to force the material into the rotor housing.
6.10 Remove a Blockage
WARNING!
Put the machine in a safe condition before
you remove a blockage. Do not reach into the
machine when it is not in a safe condition. When
the machine is not in a safe condition, there are
crush, sever, and entanglement hazards that can
cause serious injury or death.
WARNING!
The rotor knives are very sharp. Be careful when
you remove a blockage from the lower rotor
housing.
W026
CAUTION!
Wear thick work gloves to remove a blockage.
Thick work gloves give some protection from
sharp objects and splinters.
The machine is designed to handle a wide range of materials.
However, if material collects in the machine, follow this
procedure to clear the blockage:
1. Set the machine to a safe condition.
For instructions, see
Safe Condition on page 9 .
2. Remove all of the material from the chipper hopper.
3. Remove material from the discharge chute and deflector.
Use a stick to pull material out of the discharge chute. Make
sure that the discharge chute and deflector are clear.
4. Start the machine to see if the blockage is cleared.
If the machine does not operate, remove the blockage from
inside the machine.
For instructions, see
Remove an Internal Blockage on page
35.
Operating Instructions
BXT36S
Wood Chipper
34