Wallenstein BXT36S, Руководство оператора

Страница: 63 / 72

Problem Possible cause Solution
The machine
needs more
power or the
engine stalls.
The discharge chute is blocked. Remove all material from the discharge chute. For instructions, see page
34.
Too much material is being put into the chipper
hopper.
Put smaller amounts of material in the chipper hopper.
Material is being put into the chipper hopper
too quickly.
Put large material into the chipper hopper slowly.
The rotor is blocked. Remove the blockage. For instructions, see page 34.
Wet (green) material does not discharge. Wait for the material to dry or alternate between dry and wet material.
The ledger knife clearance is incorrect. USet the ledger knife clearance. For instructions, see page 59.
The knives are not sharp or the clearance is
incorrect.
Check the rotor and ledger knives. If necessary. rotate, sharpen, or replace
the knives. For instructions, see page 57 and page 58.
There is a problem with the engine. See the engine manufacturer's manual.
The drive belt is
noisy or there is
premature wear.
The drive belt is loose, worn, or the tension is
too tight.
Examine the drive belt. If necessary, adjust the tension or replace the drive
belt. For instructions, see page 53.
An incorrect replacement belt was installed. Replace the drive belt. For instructions, see page 53.
The rotor sheave is misaligned. Check the rotor sheave alignment. If necessary, adjust the alignment. For
instructions, see page 56.
The rotor is blocked. Remove the blockage. For instructions, see page 34.
The rotor sheave is worn. Examine the rotor sheave and bearings. If necessary, replace the
components.
There is lubricant (for example, oil or grease)
on the drive system components.
Find the source of the lubricant and correct the situation. Clean the drive
system components. If necessary, replace the drive belt.
The rotor bearings are worn or damaged. Examine the rotor bearings. Replace a bearing that is worn or damaged.
BXT36S
Wood Chipper
Troubleshooting
63