Wallenstein BXT36S, Руководство оператора

Страница: 62 / 72

10. Troubleshooting
WARNING!
Before troubleshooting, read and understand the
Service and Maintenance Safety on page 44.
Set the machine to a safe condition.
For engine troubleshooting, see the engine manufacturer's
manual.
The following table lists some of the problems that can occur
and gives possible causes and solutions.
If you find a problem that is difficult to solve, even after reading
this information, please contact your local dealer, the distributor,
or Wallenstein Equipment. When you contact someone, please
have the serial number of your product available. To find the
serial number on your machine, see
Serial Number Location on
page 5.
Problem Possible cause Solution
The rotor does
not turn.
The discharge chute is obstructed. Remove all material from the discharge chute. For instructions, see page
34.
The rotor is blocked. Remove the blockage. For instructions, see page 34.
The drive belt is loose or broken. Set the drive belt tension. For instructions, see page 54.
The clutch is seized. Replace the clutch.
Material is
moving into the
machine too
slowly.
The engine or rotor speed is too slow. Set the engine throttle to Fast to increase the rotor RPM. See page 21.
The knives are not sharp or the clearance is
incorrect.
Check the rotor and ledger knives. If necessary, rotate, sharpen, or replace
the knives. For instructions, see page 57 and page 58.
The rotor knife angle is incorrect. Sharpen the rotor knives to the specified 45° angle and check that the
knives are installed correctly. For instructions, see page 58.
The discharge chute is blocked. Remove all material from the discharge chute. For instructions, see page
34.
There is unusual
machine
vibration during
operation.
A rotor knife is broken or missing. Check the rotor knives. If necessary, rotate, sharpen, or replace the knives.
For instructions, see page 57.
The rotor could be be bent. Turn the rotor to see if it wobbles. If the rotor wobbles, replace the rotor.
The rotor bearings failed. Replace the rotor bearings.
Fasteners are loose. Use a calibrated torque wrench to torque the fasteners to the correct
specifications. See page 65.
The engine does
not start.
The emergency stop button is on. Reset (turn off) the emergency stop button. Turn the button clockwise and
pull. See page 21.
There is a problem with the engine. See the engine manufacturer's manual.
The clutch is seized. Replace the clutch.
The wood chip
quality is poor.
The knives are not sharp. Check the rotor and ledger knives. If necessary, rotate, sharpen, or replace
the knives. For instructions, see page 57 and page 58.
The drive belt is loose or worn. Examine the drive belt. If necessary, adjust the tension or replace the drive
belt. For instructions, see page 53.
The material being chipped is poor quality. The material is small or rotting. Mix the material with higher quality
material.
The ledger knife clearance is incorrect. Set the ledger knife clearance. For instructions, see page 59.
Troubleshooting
BXT36S
Wood Chipper
62