Wallenstein BXT36S, Руководство оператора

Страница: 52 / 72

9.6.4 Clean the Battery
When the battery cable ends are not connected to the battery
terminals, keep them away from the battery.
1. Disconnect the battery cable from the negative (–) battery
terminal.
2. Disconnect the battery cable from the positive (+) battery
terminal.
3. Apply a coat of baking soda to the battery terminals and
battery-cable ends.
4. Pour a small amount of water over the baking soda.
5. Use a wire brush to clean the battery cable ends and the
terminals.
6. Rinse the battery cable ends and terminals with clean
water.
7. Wait until all of the water evaporates or use compressed air
to remove the water. Make sure that the battery cable ends
and terminals are fully dry before connecting them.
8. Connect the positive (+) battery cable (usually red) to the
positive (+) battery terminal.
9. Connect the negative (–) battery cable (usually black) to the
negative (–) battery terminal.
10. Apply a coat of dielectric grease or petroleum jelly to each
battery terminal.
9.6.5 Charge the Battery
IMPORTANT! Do not fast charge the battery. Use a battery
charger that is between 4 A and 7.5 A. Do not use a charger
that is higher than 10 A.
Always read and obey the information that is provided with
the battery and the battery charger. For more information and
instructions, contact the battery manufacturer and battery
charger manufacturer.
1. Remove the battery from the machine.
For instructions, see
Remove the Battery on page 51 .
2. Use a battery carrier to lift the battery or put your hands on
opposite corners of the battery.
Keep the battery level to avoid spilling battery acid through
the vents.
3. Put the battery in a dry, cool place that is away from activity
and has good air flow.
4. Use a battery charger to charge the battery.
For instructions, see the battery charger manufacturer
information.
9.7 Tire Maintenance and Safety
WARNING!
Take the machine to a qualified dealer or
distributor to have a tire mounted on a wheel
or rim. Do not mount a tire on a wheel or rim
without the correct equipment and experience.
Incorrectly mounting a tire can cause an
explosion that can result in serious injury or
death.
IMPORTANT! Replace worn tires with tires that meet the
original tire specifications. Do not undersize tires.
• Torque the wheel lug nuts to the correct specification daily.
For torque specifications, see
Lug Nut Torque on page
66.
• Check the tire pressure before towing the machine on a
roadway. See the tire sidewall for the correct pressure.
• At a minimum, check the tire pressure every 100 hours of
operation or annually.
Service and Maintenance
BXT36S
Wood Chipper
52