Wallenstein 2E9US111XNS091454, Руководство оператора

Страница: 51 / 72

BXTR6438
Trailer Wood Chipper
Service and Maintenance
51
6.5 Engine Oil – Changing
Change engine oil every 100 hours.
Refer to the engine manual included in the manual tube for
information on changing the engine oil and filter.
A remote engine oil drain is located on the rear of the machine
on the right-hand side.
01591
Fig. 40 –
Remote Engine Oil Drain
Review engine instruction manual for specific instructions on:
• Oil
• Oil filter
• Air cleaner
• Fuel filter
• Fuel lines
6.6 Hydraulic Oil Fill
The hydraulic tank is located next to the fuel tank. A site glass
that shows the level of the oil in the tank (located just above the
tool box lid).
Hydraulic oil level should be checked daily, and the quality of
the oil should be inspected every 50 hours. If the oil is dirty or
smells burnt, it should be replaced.
1. Allow the engine and muffler to cool.
2. Clean area around fill cap and remove cap.
3. Using a clean funnel, fill the tank according to the oil level
gauge:
• When filling the tank with oil, the window of the site
glass will also fill with oil as the level gets higher in the
tank.
• Never fill the oil tank above the site glass.
• Do not run the machine with the oil level below the site
glass.
• Reservoir Capacity 7 US gal (30 L).
• Use Dexron III hydraulic oil for all operating conditions.
4. Install fill cap securely and wipe up any spilled oil.
Check levels after changing filters or servicing hydraulic
components
The proper level is when the oil is visible in half the glass
window.
If the level is not visible in the sight glass, add oil.
01570
Fig. 41 –
Hydraulic Tank Oil Level Check
.