Wallenstein 2E9US111XNS091454, Руководство оператора

Страница: 39 / 72

BXTR6438
Trailer Wood Chipper
Operating Instructions
39
5.8 Starting Procedure
1. The Wood Chipper should be set up and ready to run.
2. Set park brake if connected to tow vehicle.
3. Lower the support leg stand.
4. Close the choke if the engine is cold.
5. Move the throttle to its 1/4 throttle position. (If the throttle
is set any higher the centrifugal clutch could potentially
engage and stall a cold engine.)
6. Turn the ignition key to RUN, then turn fully clockwise
to Start to engage the starter. Release the key when the
engine starts.
In a starting attempt, pause briefly at RUN to power
up system electronics.
7. Operate at low idle for a few minutes to allow the engine to
warm.
8. Gradually open the choke.
9. Turn the discharge head to its desired position.
10. Slowly increase the engine speed to engage the rotor drive.
11. Increase throttle setting to maximum speed for operation.
12. Ensure that the rotor is up to speed, start feeding material
into hopper.
5.8.1 Stopping:
1. Stop feeding material into the hopper.
2. Slow engine to idle.
3. Turn ignition switch off.
5.8.2 Emergency Stopping
If an emergency occurs:
• Shut off the engine.
• Correct emergency situation before restarting engine and
resuming work.
01030
1
2
3
Fig. 30 –
Engine Controls
1. Throttle Lever
2. Choke Lever
3. Ignition Switch