wallas 40ea, Руководство пользователя

Страница: 28 / 41

40ea manual
- 27 -
Instructions for attachment to the flue
Accessory 4880 is required for the installation.
1. Cut the flue-gas pipe, the insulation channel and the cover sheet metal to a length at which they extend to the inner
surface of the flue.
2. Fasten the hoses to the heater with clamps. The flue-gas pipe must be tightened firmly with a pipe clamp.
3. Put the heater in place, and fasten it to the floor or the base housing.
4. Insulate the joint between the flue-gas hose and flue with acrylic compound.
5. The device is ready for use after you connect the power cord and the fuel hose.
Note!
If you choose to lead in the combustion air from under the floor, ensure there is sufficient ventilation in the foundations
beneath the floor. Install the protective spiral on the end of the hose.
In a tall (over 5 m) flue, with a large cross-sectional surface (over 15x15 cm), the temperature of the flue-gases
decrease so much that the moisture in them condenses, resulting in funnel corrosion and a weakened air flow. Due to
this, a brick flue should be cased with a stainless steel pipe (diameter: 50-70 mm) and the gap between the pipe and
the flue filled, for example, with LECA.
Combustion air must not be taken from the flue.