![background image](http://html1.mh-extra.com/html/wallas/40ea/40ea_manual_3234513014.webp)
40ea manual
- 13 -
12 V direct current system
Connect the red wire of the power cord to the plus terminal of the battery and the black or blue wire to the minus
terminal. A 15 A main fuse must be installed near the battery on the red plus wire of the power cord. See picture.
24 V direct current system
If the device is to receive power from a 24 V system, always connect a charging voltage reducer and a 12 V battery
before connecting the device. Without the battery the voltage reducer will not be enough on its own as it cannot
generate the large amount of current the glow plug requires. After the 12 V battery, the connection is the same as in a
12 V system.
Checking the connection
The device consumes most power when it is started up (glowing). At this point voltage losses are also at their highest.
During the glowing phase, the voltage must be at least 9,5 V measured at the quick coupling. If the voltage is lower
than this, the device may not start.
All wires needs to be mounted with smooth bending and equipped with strain relief.
Содержание 40ea
