Getting Started
Power Connection
IMPORTANT: The set-top box is designed to
operate on 12 V DC. For this, an adaptor is used
which gives 12 V voltage. Connect this adaptor to
a system that supplies 220-240V AC,50Hz.
• After unpacking, allow the set-top box to reach the
ambient room temperature before you connect the
set to the mains.
Antenna & Satellite Connection
•
This illustration shows how to connect an antenna.
• Use
ANTENNA IN
to connect to an antenna
system.
Connect all cables before plugging into the mains.
When the set top box is first powered up please
wait until the box is initialized before activating
the receiver since booting of software will take
some time. Plug the mains. Please wait until unit
is initialized. This may take almost a minute.
This product conforms with the latest European
Union Power Consumption Regulations and
features a low power standby mode.
The
products enters into the low power standby mode
approximately 2-3 minutes later after the standby
button is pressed to turn off the unit.
When the
low power mode is activated, the LED goes RED.
When you press the standby button during low
power mode, it may take a minute until the product
is initialised.
However, if you press the standby
button before the low power mode is activated, the
unit will be initialized in a couple of seconds (Active
standby mode).
Although it is not recommended
for enviromental reasons, you may disable low
power mode in your product at setup –configuration
menu.
Auto Power Down:
This box will automatically switched from active
mode into standby mode, after less than three
hours in active mode, following the last user
interaction and/or a channel change with an alert
message two minutes before going in to standby
mode. The Automatic power-down can be set as
disabled,
2 hours, 3 hours, 4 hours, 6 hours
or
8hours from the configuration menu.
Important Note :
If there is any ongoing
programme recording or if any EPG programme
recordings and/or manual recordings is set to a
nearby time, the unit does not switch to low power
mode and remains in active standby mode until
recording tasks have been finished. At low power
mode, the unit initializes a couple of minutes before
the actual time of the incoming recording task.
Important Note :
The unit initializes
from time to time to receive updates from
the EPG broadcast in order to synchronize
EPG
recording tasks properly. After getting
updates, the unit switches to low power mode
automatically. This takes a short while and it
is not a malfunction.
Power On-Off
SCART (TV)
ETHERNET
HDMI OUTPUT
USB
5V DC ,500mA
OPTICAL
AUDIO OUT
ANTENNA IN
ANTENNA OUT
35029492
8
