Wahl HSI3000 Series, Руководство пользователя

Страница: 6 / 32

Page 6 of 32
3.2 Switching on the HSI3000
The HSI3000 features an On/Off power button above the display. The
HSI3000 is switched on by holding the power button down for more
than one second.
The HSI3000 takes approximately twenty seconds to become
operational. During this time a number of audible clicks will be heard.
This is normal as it is part of the calibration procedure. After start-up
these clicks continue, but become much less frequent.
For best measurement results the imager should be switched on at least
5 minutes before use.
Figure 6: Switching on the HSI3000
3.3 Information Splash Screen
The HSI3000’s splash screen appears for approximately 20
seconds when the imager is switched on.
It displays the time and date so the user can check that any
images saved will be recorded with the correct time and date.
The time and date must be manually set. (see Section 3.4.7.4)
Figure 7: Splash Screen