Wahl HSI3000 Series, Руководство пользователя

Страница: 4 / 32

Page 4 of 32
2.2 Powering the HSI3000 Series Thermal Imager
The HSI3000 thermal imager operates with a rechargeable battery, or from AC mains power.
2.2.1 Using Battery Power – Inserting the Battery
1. Make sure unit is off. Open up the battery compartment on the bottom of the HSI3000 thermal
imager by sliding the battery cover off as indicated in Figure 2.
2. Insert the rechargeable battery. The polarity of the battery is shown on the battery case.
3. Replace the battery cover.
Remove Battery Cover Install Battery
Replace Battery Cover
NOTES:
Figure 2: Inserting the Rechargeable Battery.
•
The above method also applies to replacing the battery, but make sure the HSI3000 is switched off before removing the
battery.
•
The rechargeable battery will power the HSI3000 thermal imager for approximately 4 hours.
•
The battery indicator appears on the screen when the imager is switched on. It has the following four stages and each
stage corresponds to approximately one hour of operation.
4 hours 3 hours 2 hours 1 hour
Figure 3: Battery Indicator Levels
! CAUTION: If the HSI3000’s battery indicator flashes, the battery power is running low and it needs to be
charged or replaced within 10 minutes.
2.2.2 Using AC Mains Power
1. Make sure the thermal imager is turned off.
2. Connect the provided 12V power supply into the socket on the side of the HSI3000 imager; see
Figure 4.
3. Attach the appropriate supplied regional adapter to the power supply.
4. Plug the power supply into a mains socket.
5. Switch on the thermal imager.
! CAUTION: When using AC mains, use only the power supply included with the HSI3000. Using other power
supplies may damage the HSI3000 Thermal Imager.
NOTE:
•
The mains power supply included with the HSI3000 is for powering the HSI3000; it will also recharge the batteries
(see Section 2.2.3).