Wahl HSI3000 Series, Руководство пользователя

Страница: 26 / 32

Page 26 of 32
5.3.1.1.4 Tools
The Tools menu contains the following:
•
Imager Comms Config…
•
Capture From Imager…
•
Reset Isotherms
•
Dock Options…
1) Imager Comms Config… - This is used to transfer single images taken from the live image in the
HSI3000 to a PC via a USB connection. The first time the imager is connected to a PC via USB, the USB drivers
must be installed to the PC from the CD.
1. Switch imager on
2. connect USB cable to imager
3. connect USB cable to PC
4. the Windows XP/2000 “found new hardware wizard” will appear
5. direct the wizard to the “USB Virtual Com Port” folder on the CD, and click “next”
You may have to repeat parts 4 and 5 to install the second part of the 2-part USB driver. Once the drivers
have been installed, select Imager Comms Config to open the window in Figure 44 below. Select the “USB
Serial Port (COM X)” from the list, click “Test Port” and then click “OK”.
Figure 44: Port Selection
2) Capture from imager… - After setting up the Imager Comms Config, select this to take a new image
from the imager. The HSI3000 imager must be switched on and connected via the USB cable provided to a
USB port on your computer. The file transfer takes approximately 10 seconds. As always when taking an
image, make sure the imager is correctly focused on the target.
3) Reset Isotherms – This moves the two isotherms back to their default positions. The isotherms must be
displayed to see the effect of this tool.
4) Dock Options – This selects whether to dock the Options dialog box into the application window or
whether to have the Options in a free-floating window of its own. If the Options box is not displayed, this
menu item will be disabled.
Figure 45: Options Docked and Free-Floating