WAGNER PLASTCOAT 1030, Руководство по обслуживанию

Страница: 18 / 31

18
PC 1030
GB
12
REPLACEMENT OF SEALS AND O-RINGS OF THE NEW LANCE
2338828 Assembly tools for the new PC lance
Content of the kit
1, 2 Guiding tools for inserting the closing cylinder
3 Inserting tool for the seal 2319 231
Assembly of the closing cylinder and new o-rings
Attention! The inside of the lance body
must be clean. Otherwise it‘s possible that
the closing cylinder can‘t be assembled.
1. Insert both guiding tools (1 and 2) in the front and back side
of the lance body (4). Make sure that these parts are in line
with the shape of the closing cylinder.
2.
Lubricate closing cylinder (5) and all seals and o-rings.
3. Insert the closing cylinder (5) with the help of the guiding
tools (1 and 2) into the lance body.
Attention: Avoid dam-
age to the o-rings due to the sharp edges.
4. Fully press the closing cylinder to the bottom of the lance
body with the help of a bench vice.
5. Countersink the slide bush (6) with the help of a hammer and
a chisel until the groove for the retaining ring is visible.
6. Secure the closing cylinder with the retaining ring (7).
7. Insert the seal washer (8) with the inserting tool (3) into the
lance body.
8. Lubricate o-Ring (9) and insert it into the hose connection
(10). Insert the hose connection completely into the lance
body.
9. Secure the thread with Loctite 243 (blue).
1 2 3
4
5
6
7
8
9
10
REPLACEMENT OF SEALS AND O-RINGS OF THE NEW LANCE