WAGNER GM 50000EAC, Перевод оригинального руководства по эксплуатации

Страница: 21 / 108

21
R1
R3
R2
B_03182
2
4
3
OPERATING MANUAL
EDITION 05/2015 ORDER NUMBER DOC2319150
5.2
MODE OF OPERATION
When the spray gun is connected to the control unit and the
control unit is switched on, the pre-defi ned recipe (R1, R2 or
R3) is shown on the gun display (2) as follows.
Recipe 1
Recipe 2
Recipe 3
Recipe change R1 R2 R3 R1
Press the operating button (4) and hold the button pressed
for at least 2 seconds to go forward 1 recipe.
Display (2) = Recipe values changed temporarily:
If the operating key (4) is pressed for 2 seconds, the saved recipe
values for the previously selected recipes numbers will be
reloaded from the memory.
During spraying mode (trigger lever pressed), the status is shown in the display (2) by LEDs.
LED display Description
LEDs 1 - 3 light up green. The spray gun is working in an optimal
high-voltage spray current range.
One or both right-hand LEDs illuminate
in orange. Spray current too high.
Possible causes:
(Warning display: You can continue
working without any limitations.) - Spray gun too close to the work piece
- Contamination of the spray gun
- Paint conductivity too high
5.1.1
SECURING THE SPRAY GUN AGAINST ACTUATION
Secure the spray gun against actuation:
Use the trigger lock (11) to engage the trigger (12) .
Note : To secure the entire spraying system, pressure must be relieved as described in
Chapter 7.3.4.