Wacker Neuson Telehandler TH412, Руководство оператора

Страница: 248 / 362

6-6
BA TH412 * 06/2017 * 4512_6-2_Verladen_en.fm
6 Transportation
In order to avoid injury or accidents, observe the following
instructions when loading the machine:
• The transport vehicle must be of sufficient size.
- Refer to chapter “Technical data” for the weight and
dimensions of the machine to be loaded:
➥
Vehicle weight on page 9-12
➥
Dimensions of 29.9 kW machine on page 9-14
• Remove any mud, snow or ice from the tires so that
the machine can be safely driven onto the ramps.
• Secure the transport vehicle against unintentional
movement.
• When positioning the machine on the platform, ensure
that the center of gravity of the load is as low as
possible and in the longitudinal center line of the
transport vehicle if possible.
• The permissible maximum weight or the permissible
axle load of the transport vehicle must not be
exceeded during loading or transportation.
• Ensure that the load does not fall short of the minimum
axle load of the transport vehicle, otherwise the
steering behavior is strongly affected.
• Place partial loads so as to ensure an even load on all
axles of the transport vehicle.
• Secure the machine so that it cannot slip, slide, roll, tip
over or fall, or cause the vehicle to tip over under usual
transportation conditions.
- Usual transportation conditions are conditions in the
which the brakes are slammed on, evasive
maneuvers are performed with the vehicle or in
which uneven roadways are traveled on.
- Auxiliary means are, for example, anti-slip bases
and linings, ratchet straps and chains, clamping
beams, protective paddings, nets, edge protectors,
etc.
• Always use the existing tie-down points when using
ratchet straps and chains.
• Adapt the travel speed to the load, road and traffic
conditions, and handling of the transport vehicle.