Wacker Neuson E1100, Руководство оператора, Страница: 79 / 162

E 1100 Burner Setup
wc_tx001811gb.fm
79
Continued from the previous page.
When Adjust the burner:
„
Before operating the machine at elevations 305 m (1,000 ft) above or below the
location of the previous adjustments
„
Before starting at a new job site
„
After any burner maintenance or repair has been performed
„
If burner performance is in question
Procedure Follow the procedures below to set up the burner.
1. Shut down the machine.
2. Set the burner electrodes.
(See topic 6.1 Setting/Checking the Electrodes .)
3. Check the burner nozzle.
(See topic 6.2 Checking/Replacing the Nozzle )
4. Check/set the “Z” distance.
(See topic 6.3 Setting the “Z” Distance .)
5. Set the air settings.
(See topic 6.4 Adjusting the Air Settings )
6. Start the machine and the burner.
7. Check/set the fuel pressure.
(See topic 6.5 Setting the Fuel Pressure )
8. Conduct a smoke spot test. Follow the smoke spot tester manufacturer’s
instructions and the general guidelines below.
„
Use the access hole in the exhaust stack.
„
Several samples should be taken as the heater warms.
„
The final sample should be taken just before the heater reaches 71°C (160°F).
This procedure continues on the next page.