Wacker Neuson E1100, Руководство оператора, Страница: 61 / 162

wc_tx001903gb.fm
61
E 1100 Operation
4.24 Resetting a Low HTF Fault
Requirements
„
Genuine Wacker Neuson Heat Transfer Fluid, or
„
Dowfrost HD 50 Heat Transfer Fluid
NOTICE: Use only factory-recommended Heat Transfer Fluid (HTF). Failure to do
so may damage the machine.
Important The procedure for routine filling of the HTF reservoir differs slightly from that when
a low level fault is encountered. If you are filling the reservoir during normal
operation, see topic
Filling the HTF Reservoir .
Background The HTF reservoir includes a sensor that will trigger the low-level shut-down device
to stop the machine’s function if the HTF falls below the minimum operational
capacity. During a low HTF level condition the following occurs:
„
The control panel low level fault light illuminates
„
Power is cut to the burner
„
Power is cut to the pumps
„
The low-level shut-down device “LOW WATER” light illuminates
Resetting a
low HTF fault Follow the procedure below to reset a low HTF fault.
1. Move the burner switch to the OFF position.
2. Move the pump switch to the OFF position.
3. Clean the fill hose.
4. Move valve #2 to the maintenance position (valve handle pointing up).
5. Place the open end of the fill hose (a) into a container full of HTF.
This procedure continues on the next page.
wc_gr008699
a
2