Wachs DW Guillotine, Руководство пользователя

Страница: 35 / 52

Chapter 4, Maintenance: Replacing the Cutting Wire
E.H. Wachs Part No. 29-MAN-10, Rev. A 31
Figure 4-3. Remove the wire from the drive wheel
first.
5.
When putting on the new wire, make sure it is
installed in the correct direction. The machine will not
cut properly with the wire installed wrong.
Inspect the wire closely to
see the taper of the bead.
Figure 4-4. Check that the wire is installed in the cor-
rect direction. The thinner end of the cutting bead
should lead.
6.
Install the new wire over the drive wheel, then over
the idler wheels.
NOTE
Thin end
of bead Thick end
of bead
Cutting direction