6 Configure the Operation Modes
The
Syslog
function may of course be
Off
or
On
. In the On-state the NetCom
+
sends all the log
information to a computer defined by
Destination
. A special software often called Syslog Daemon
has to receive these data. The Option of
Facility
is a criteria for the Daemon how this will
organize the data received from the NetCom
+
.
In contrast for
Debuglog
the NetCom
+
behaves as the server. When this option is
On
the NetCom
+
waits for incoming TCP connections to the configured
Debug Port
. The NetCom
+
sends all logging
information via this connection. For manual use a software like Telnet is suitable, especially if it
has the option to save all received data.
6.2.3.8 Save
Web: menu “Tools”, at bottom.
As usual at the bottom of the web page below all the options there is the button
Save
. This will
store the configurations done for Logging (
6.2.3.7
).
6.2.4 Reboot
Web: menu “REBOOT”.
In your web browser, click the Icon of
REBOOT
to restart the NetCom
+
firmware.
Attention: This option will discard all configuration changes, unless they have explicitly been saved.
Naturally it will also disconnect all other clients using serial ports or the Telnet configuration
menu.
6.2.5 Save&Exit Menu
This section of configuration is only available via the terminal interface, i.e. via Telnet or serial
port. Modifications in the configuration of the NetCom
+
are not active, until they are explicitly
saved to the Flash Memory of NetCom
+
. This menu also allows to discard all changes, and even
to restart the firmware.
6.2.5.1 Save Parameter
Telnet: “Save&Exit”, option “Save Parameter”.
When some changes are done, these modified settings should be saved. A confirmation is requested
before doing this.
Save&Exit
+------------------+
|
Save Parameter
|
|
Exit
|
|
Reboot
|
+------------------+
+---------------------------------+
| Do you want to save the changes |
|
Yes
No
|
+---------------------------------+
Figure 95: Menu Save modified Parameters in Telnet
The Telnet interface is still active when this operation is finished.
September 2016
NetCom Plus User Manual
92
