4 Windows Virtual COM Driver
Enable
:
The configuration shown here is active, when the pre-defined performance levels are
used. When using the ‘Advanced’ option, Remote Flow Control is completely disabled.
Enable as required. While it is best practice to configure as figure
34
, you can disable
certain events here.
CTS, DSR, Tx XON/XOFF
: these control the output of data to the serial port.
RTS, DTR, Rx XON/XOFF
: used to stop transmission from the connected device.
An application has the option to use any combination of these methods at the same time. The
command to use them is transferred to the NetCom
+
. For example, if the port is configured to
use Hardware Flow Control, the NetCom
+
will control the RTS line, and observe the CTS line.
If requested, any of these methods may be unchecked. In that case the driver software on the
computer will control the lines.
Override App Settings
: In rare situations it is necessary to ignore the applications configuration.
Check this box, and select the Flow Control functions to use with the device.
Limits
:
These buttons are prepared for future software versions.
September 2016
NetCom Plus User Manual
44
