With the retract in the retracted position, carefully move the gear door on the strut until the gear door nearest with the
gear door on the fuselage, mark on the struts.
With the retract in the extended position, Glue the rings of
gear door to the struts with thin CA glue.
Gear door
Wooden ring
Strut
Sand here
Sand here
Lightly sand the wooden rings to be sure that
the struts locks in
position.
retracted
CA
RARE BEAR
SECTION
- STRUTS
22
Important: When you “on” the retract swicth, if the retract
gear does not retracted completely, you immediately “off”
the retract switch. If the retract gear does not extend, use
your finger to push the retract gear to the completely
retrated position, it will extend.
Then use the hobby knife to remove the place where the
retract gear is entangled.
