A
A’
B
B’
Trial fit the horizontal stabilizer in place on the fuselage. Check the alignment
of the horizontal stabilizer. The distance must be equal on both sides
. If not, adjust the stabilizer until the measurements
(A=A’ and B=B’ and C=C’)
are the same.
If the fit is overly tight, it may be necessary to
lightly sand the hole on the fuselage.
Step 1 A
2
* WARNING: When removing any covering from the airframe, please ensure that you secure the
cut edge with CA or similar cement. This will ensure the covering remain tight.
Cut away only
the covering*
Step 11A
5x20mm screw
C
C’
5x20mm screw
...1 (for each side)
RARE BEAR
SECTION
- JOINING THE WING continued
11
RARE BEAR
SECTION 1 - HORIZONTAL STABILIZER
2
