When you are satisfied with the alignment , use a pencil to
carefully trace around the top and bottom of the stabilizer
where it meets the fuselage. Note, it is important not to
disturb the alignment of the stabilizer. The pencil should
leave a light indentation in the covering.
Pencil
Remove the horizontal stabilizer from the fuselage. Using a sharp hobby
knife, carefully cut away the covering inside the lines which were marked
in Step
.
13A
Be cautious not to cut into the wood-this will weaken the structure.
Step 13A
Step 13B
Step 13C
Again, trial fit the horizontal stabilizer in place on
the fuselage and adjust the alignment as described
in Step
A.
12
Secure the stabilizer in place using the
.
5 minutes Epoxy
5 minutes
Securely glue together. If coming off during flight,
you lose control of your air plane.
RARE BEAR
SECTION 1 - HORIZONTAL STABILIZER continued
3
A B
