VPG BHL Nobel AST 3, Инструкция по эксплуатации, Быстрая установка

Страница: 7 / 26

Analogue Signal Transmitter AST 3
3
View alternatives
AST 3P set-up may allow display of more views than Weight value. In that case
the function keys and are used, according to figure 3, to select a view.
Weight value, normal view.
This view displays the actual measurement value, here called weight value, and
the instrument address. For the relays in use the status, On or Off, is displayed.
Zero setting.
This view displays the weight value and the address, and on the second line
the text ‘Zero’ above the key .
Zeroing of the weight value is performed as is pressed.
The zeroing performed in this view is only temporary. After power-off or reset
it will be replaced by the zero setting from the latest calibration.
Analogue output.
This view displays the weight value and the address, and also the actual analogue
output signal.
Level settings.
This view displays the switching levels for the two supervising channels.
If these channels are not in use, level 0 is displayed.
Input signal.
This view displays the actual input signal from the connected transducer(s).
The instrument address and status for the used relays are also displayed.
S/N:, Progr.
This view displays the instrument serial number and the name of the installed programme.
Weight value
R1: On R2: On
0.18200mV/V 001
Input signal
5.430 V
Analogue output signal
Progr. XXXXXXXX
S/N: XX-XXXX
S/N:, Progr.
L2 0.0 kg
L1 99999.9 kg
Level settings
Start up/Reset
Zero
Zero setting
123.4 kg 001
Set On/Off in Zero function
Set On/Off in More views
Set On/Off in More views
Set On/Off in More views
Set On/Off in More views
R1: On R2: On
Normal view.
View alternatives.
123.4 kg 001
123.4 kg 001
Figure 3. AST 3 in Operating mode can always display the weight value.
Depending on the setting, display of alternative views
can be selected by keys + and –.