VPG BHL Nobel AST 3, Инструкция по эксплуатации, Быстрая установка

Страница: 17 / 26

Analogue Signal Transmitter AST 3
13
14. Read the zero offset.
By installation later of a replacement instrument, it is useful to know
the total zero offset value for the scale.
Press
+
to get parameter ‘Zero offset’ displayed.
Zero offset
X.XXX kg
Make a note of the zero offset value in the Quick set-up list, appendix 1.
15. Exit ‘Quick set-up’.
Press ESCAPE to get to ‘Main menu Exit set-up’.
Main menu
Exit set-up
16. Save the changes.
Before ‘Quick set-up’ is closed, the new parameter values should be saved,
i.e. copied to a specific memory in the instrument.
Alternatively the new values can be cancelled, and all parameters will resume
the values they had before ‘Quick set-up’ was started.
Press ENTER to get the sub menu displayed.
Save changes?
No Esc. Yes
(Press if you do not wish to exit from the set-up mode.)
Press to answer ‘Yes’, and save the new parameter values.
Press to answer ‘No’, and cancel the new parameter values.
In both cases ‘Quick set-up’ is finished and the instrument switches over
to Operating mode, displaying a measurement value that depends on
the load and the active parameter values.
000.00 kg 001
R1:On R2:On
The scale is now ready for use.