VZR.2515.001IM
CUBE C-05 tripod turnstile
Installation Manual
24
5.2 Control panel connection
The turnstile can be supplied with two different control panels:
1. Basic control panel BCP 01
2. Universal control panel UCP 02 with extended capabilities.
1. Basic control panel BCP 01 The case of control panel contains only
switching buttons, there are no electronic components in it. The control panel
allows to control the turnstile, provides execution of commands to allow one-time
passage to the right, left, stop and anti-panic commands. The execution of these
commands is ensured by connecting the five-wire cable of this console to the
Access Control System
inputs on the cross-board. This control panel provides a
short circuit between the cross-board inputs LEFT, RIGHT, STOP, AP and GND.
Connected ACS system is connected to the same contacts. The
Control Board
contacts are not used when connecting this control panel. When using this control
panel, it is necessary to agree with the manufacturer of the external controller for
its use.
BCP 01 cannot:
1. This control panel does not have backlighting of buttons for switching on
the preset mode.
2. Provide reusable easy access to one side.
3. Provide reusable free passage on both sides
4. Provide button reassignment from right to left (button reverse)
5. Autotest mode is not enabled.
2. Universal control panel UCP 02. The control panel is a complex
programmable device. Allows, in addition to the main functions of the turnstile
control, to change the settings of the turnstile operating modes.
The panel is connected via the CAN bus with a four-wire signal cable.
It ensures:
