Pulilux PL 515
Assembly & Use
Fit the
Kobold VK 140
to the joint on the
Pulilux PL 515
.
(FIGURE 3)
The
Kobold VK 140
will remain upright
when the joint is locked perpendicular.
(FIGURE 3)
Switch off the appliances before and
always remove the plug from the power
supply before changing the pads. The
Pulilux PL 515
has a motor overload cut-
out, which triggers if the appliance
overheats. After removing the cause and
allowing the
Pulilux PL 515
to cool down
for about 15 minutes, the
Pulilux PL 515
is
ready to be used again. Always switch off
the appliance when cooling down.
Use the
Pulilux PL 515
only for dry
cleaning of hardfloors for domestical use.
Changing the pad modules
Choose the pads suitable for the floor to
clean
(see PAGE XX)
.
1.
Press the opener button fully down to
release the handle.
(FIGURE 4)
2.
Open the cowling.
(FIGURE 5)
The Hard floor and Polishing Modules are
both dual-function:
Hard floor Module:
combines cleaning bru-
shes and power pads
(see PAGE xx)
.
Polishing Module:
combines polishing bru-
shes and polishing pads
(see PAGE xx)
.
FIGURE 3
FIGURE 4
FIGURE 5
Pulilux PL 515
Technical specifications
P
L
515
69
P
L
515
68
Technical specifications
Appliance usable exclusively when connected to Kobold appliances.
Connects to the Kobold through a practical connection system.
Voltage
230V AC / 50 Hz
Power absorption
350 W
Maintenance
free motor with drive and reduction by gears
Brushes set speed
1200 rpm
Working surface area
600 cm
2
Height
approx. 99 mm
Weight
3.00 kg
Noise emission
85 dB with VK 140 system
(measured on hard floor in ideal conditions)
Protection level
IPX 0
The identification details of the product are on the label on the rear side
of the appliance.
The manufacturer reserves the right to make any changes suggested by
developing technology, at any time and without prior notice.
Assembly & Use