Never run the Electronic Brush over the
mains cord or other cables lying on the
floor.
The appliance can also be used with the
stick extended. This is more practical when
vacuum larger mattresses (for example,
double beds).
(FIGURE 18)
When using the
EB 360
on mattresses
always set suction power on the
Kobold VK
140
to minimum, in position
“1”
.
(FIGURE 19)
Never allow the appliance to operate for a
longer period than 5 seconds on a
single spot since this could damage
the surface.
Note that to protect surfaces,
when the joint of the
EB 360
is in
vertical position, brush rotation is
disabled, whereas the
Kobold VK 140
remains at the set suction power. Reset the
switch to minimum power (
“1”
) for mattress
cleaning.
Anti-damadge block
If you accidentally suck up something big
or if the mattress lining is a little loose and
the suction power of the
Kobold VK 140
is
too high, the
EB 360
automatically cuts-out
while the
Kobold VK 140
continues to
operate at the set power.
The blinking green operating light (on)
indicates a blockage.
(FIGURE 20)
Switch off the appliance, remove the plug
from the mains socket and remove the
trapped object from the
EB 360
. Switch the
Kobold VK 140
on again at minimum power
level “
1”
.
FIGURE 17
FIGURE 18
FIGURE 20
EB
360
55
EB
360
54
FIGURE 14
Use on mattresses
To handle the
Kobold VK 140
on mattresses
you can adapt it as described in chapter
Kobold VK 140
“Assembly and use -
Handling the appliances and telescoping”.
Use the special slatted brushes on
mattresses (see
FIGURE 2 at page 49
).
This makes mattress care both easy and
effective.
Be aware that some mattresses have
very special surfaces (eg. Jersey) that are
not suitable to be cleaned with slatted
brushes.
To change the brushes, refer to chapter
“Assembly & Use on carpets and
mattresses”.
Fit the mattress brushes with a slight rotary
movement on the drive shaft until they click
into place. Always check that the red cap of
the brush corresponds to the red mark on
the
EB 360
(see
FIGURE 16
).
Carefully close the cowling using both
hands until it clicks into place.
Always replace both brushes.
Switch on the
Kobold VK 140
and operate,
the green operating light on the
EB 360
indicates that the appliance is on.
Stay away from rotating brushes of the
electronic brush.
Remove the electrical plug from outlet
prior to all adaption.
FIGURE 15
FIGURE 16
FIGURE 19
Assembly & Use
Assembly & Use
