V O R S I S H D P 3 G U I
page 2 – 11
HD P3 / Aug 2006
Input
Representing input source selection, operational mode, input gain
control, balance/offset, symmetry decorrelator, absolute and relative L/R
phase, M/S capability, and pre-emphasis selection.
ANALOG SAMPLE RATE — Allowing selection of 44.1kHz or
48kHz internally generated sample rates, and the option of Auto 44.1kHz
and Auto 48kHz under which the HD P3 synchronizes to the external
sample rate of a valid applied AES/EBU input signal. Virtual LED’s in the
lower right corner of the HD P3 GUI indicate the status of the external
sample rate present at the AES input connector. The VALID LED will go
out If the Auto select frequency and the actual sample rate present at the
AES input jack differ.
MODE — Through two buttons, this determines if the HD P3 is going
to operate in “Stereo” or as two discrete channels (“Dual Mono”).
STEREO FROM CH1 - when checked, the common stereo parameters
will be controlled from the LEFT channel controls. Right channel controls
are ignored. If un-checked, the RIGHT channel controls are active and the
LEFT channel controls are ignored.
