Volvo B10M, Руководство пользователя

Страница: 133 / 148

131
TYPE DRIVE
W.B.
APPROVAL NO.
VEHICLE ID. NO.
G.V.W.
G.C.W.
AXLE LOAD
TURN TABLE LOAD
1589621 P01 PERMITTED MASS
LEGALLY
PERMITTED MASS
TECHNICALLY
2
1
3
4
KG
KG
KG
KG
KG
KG
KG
Technical Data
Identification plate
The identification plate is divided into a regulated section,
inside the inner frame of the plate, and three boxes for chas-
sis type, drive and wheelbase. The latter are not used for
buses, only for trucks.
On buses, the identification plate is located by the driver’s
seat and contains the following information:
If national gross vehicle weight or axle weight regulations are
prescribed to lower levels then the recommended, the general
agent/importer should stipulate this on the left side of the type
plate with the levels that apply.
In the case of special national approval being
required the approval number should be
marked on the type plate by the general agent/
importer.
The V.I.N.-number, i.e. the same number that
can be found on the frame member can also
be found here.
Max gross vehicle weight, technical in kg.
Technical weight refers to the weight the bus
was constructed for.
Max front axle weight, technical,in kg.
Max rear axle weight, technical, in kg.
(in applicable cases max axle pressure,
technical, in kg for the 3rd axle)