Volvo 322001, Руководство оператора

Страница: 291 / 414

W W ARNING
Risk of scalding and severe burns to unprotected skin.
High-pressurised hot coolant may rush out of expansion tank and
cause severe burns. Before removing the expansion tank
pressure cap:
Shut down the engine.
Allow the engine to cool
Turn the pressure cap slowly to release any pressure.
1 Place the machine on level ground in service position B, see
page
247.
2 Climb the machine by using the handholds and the indicated
footsteps.
3 Open the engine hood.
4 N N OTE!
The coolant level should be checked after the engine has been
run until warm and then cooled down.
Check the coolant level in the expansion tank. The level should
be between the MAX and MIN marks on the expansion tank.
5 N N OTE!
Coolant shall always be filled through the filling cap (1). Do not
fill the coolant through the pressure cap (3) in the expansion
chamber.
In case of low level, remove the filling cap (1) and top up until
the level is in the middle between MIN. and MAX. For coolant
specifications see page
331.
C C o o o o l l a a n n t t , , dr r a a i i n n i i n n g g
In case too much coolant was filled in it can be drained according
to below procedure.
V1152161
1 2
3
Expansion tank
1 Filling cap
2 Coolant level
3 Pressure cap
Ma a i i n n t t e e n n a a n n c c e
Ma a i i n n t t e e n n a a n n c c e ser r v v ic c e, , ev v er r y y 25 5 0 0 ho o u u r r s s 28 8 9 9