109
Jump starting
CAUTION:
Improper hookup of jumper cables or use of other than 12-volt
batteries could result in damage to equipment and/or the battery.
WARNING!
•
Do not connect the jumper cable to any part of the fuel system or
to any moving parts. Avoid touching hot manifolds.
•
Never expose the battery to open flame or electric spark.
•
Do not smoke near the battery.
•
Batteries generate hydrogen gas which is flammable and
explosive.
•
Battery fluid contains sulfuric acid. Do not allow battery fluid to
contact eyes, skin, fabrics or painted surfaces. If contact occurs,
flush the affected area immediately with water. Obtain medical
help immediately if eyes are affected.
Failure to follow the instructions for jump starting can lead to
personal injury.
NOTE
: Refer to page 163 for information on properly maintaining
the battery.
Jump starting
Follow these instructions to jump start your car's dead battery or to jump
start another car's dead battery using your car. Although your car's
battery is located under the floor of the cargo area, jumper cables should
be connected in the
engine compartment
, to the points shown in the
illustrations.
If the 12-volt auxiliary battery to be used is in another car, check that the
cars are not touching to prevent premature completion of a negative
circuit. Be sure to follow jump starting instructions provided for the
other vehicle.
To jump start your car:
•
Switch off the ignition.
•
First connect the auxiliary battery positive (+) terminal (1) to the
positive (+) terminal in your cars engine compartment (2), located
under a small black plastic cover attached to the fuse box cover,
marked with a + sign. Remove the cover on the main fuse box if
necessary to access this terminal. See page 137.
•
Then connect the auxiliary battery negative (-) terminal (3) to the
PROPOSITION 65 WARNING!
Battery posts, terminals, and related accessories contain lead and lead
compounds, chemicals known to the state of California to cause
cancer and reproductive harm. Wash hands after handling.
ground point in your cars engine compartment (4).
Start the engine in the assisting car, then start the engine in the car
with the dead battery.
•
After the engine has started, first remove the negative (-) terminal
jumper cable. Then remove the positive (+) terminal jumper cable.
3100088m
Содержание 2006 XC70
