VOLTCRAFT 1528380, Руководство по эксплуатации

Страница: 26 / 48

26
Use the buttons "INC." and "DEC." to select a different rechargeable battery programme; use the button
"BATT. TYPE/STOP" to return to the main menu.
• If the value for the charging current must be changed, push the "START/ENTER" button. The charging current
flashes. Change the charging current using the buttons "INC." and "DEC.". Keep the respective button pressed for
quick adjustment.
• Confirm the set charging current with the "START/ENTER" button.
The maximum possible charging current depends on the rechargeable battery type, the cell number and
the max. charging output of the charging channel used.
• To begin the charging process, keep the "START/ENTER" button pressed
for longer (approx. 3 seconds).
The charger now examines the connected rechargeable battery.
If the settings are wrong, or if the charger detects a problem, an audio signal is emitted and the appropriate
information is shown on the display. You can stop the warning signal by pressing the "BATT. TYPE/STOP"
button. The charger then returns to the previous configuration menu.
• The display shows, e.g., the following data while charging:
The rechargeable battery type is shown in the upper left ("NiMH" = NiMH
rechargeable battery), the upper middle shows the charging current and the
upper right the current rechargeable battery voltage.
• The lower left shows the current rechargeable battery programme ("CHG" = "CHARGE"), in the middle the elapsed
charging time and the charged capacity in mAh are displayed to the right of this.
• Once the charging process has been completed, an audio signal is emitted (if it was not turned off).
If you wish to cancel the charging process, push the "BATT. TYPE/STOP" button.
c) Automatic Charge Mode ("Auto CHARGE")
In automatic mode, the charger checks the rechargeable battery condition
(e.g. the inner resistance) and calculates the charging current from this. You
need to set an upper limit for the charging current so that the rechargeable
battery is not damaged by a too-high charging current.
Depending on the rechargeable battery and its inner resistance, shorter charging times may be achieved in the
rechargeable battery programme "Auto CHARGE" than in the rechargeable battery programme "CHARGE" (chapter
12. b).
Proceed as in the rechargeable battery programme "CHARGE" for setting and operation (chapter 12. b).
The only difference is that you do not set the actual charging current, but the limit for the maximum charging
current that the charger must not exceed.
NiMH 2.0A 7.42V
CHG 022:45 00690
BATTERY CHECK
................
NIMH Auto CHARGE
CURRENT 5.0A