62
c) Inserting and changing the batteries
Operation of the meter requires a 9 volt block battery (e.g. 6F22 or same build). You need to
insert a new, charged battery before initial operation or when the battery change symbol
appears on the display.
Proceed as follows to insert or change the batteries:
- Disconnect the meter and the connected measuring lines
from all measuring circuits. Remove all measuring lines from
your meter. Switch off the DMM.
- Loosen the rear screw at the battery compartment lid (12)
with a matching Phillips screwdriver. Remove the battery
compartment lid from the device.
- Replace the flat battery with a new one of the same type.
Connect the battery clip to the battery in the correct polarity.
Observe the polarity as indicated in the battery compartment.
- Close the casing carefully again.
Never operate the meter when it is open.
!DaNgEr To LIfE!
Do not leave flat batteries in the meter. Even batteries protected against leak-
ing can corrode and thus release chemicals which may be detrimental to your
health or destroy the battery compartment.
Do not leave batteries lying around carelessly. They could be swallowed by
children or pets. If swallowed, consult a doctor immediately.
remove the batteries if the device is not used for extended periods of time to
prevent leaking.
Содержание 1380557
Страница 3: ...3 ...
